Avoid Exposure to Waste Anesthetic Gases
During Patient Induction

Induction of inhalation anesthesia in rodents has traditionally been accomplished via a chamber or bell jar. The animals are exposed to an appropriate concentration of anesthetic vapor and O₂ until they are rendered unconscious. Removal of the animal usually exposes the investigator to unacceptable levels of waste anesthetic gases.

VetEquip Sets the Standard
and addresses this concern!

The vented induction chamber will eliminate exposure to waste anesthetic gases that are most common with traditional induction chambers. The patient is placed into the chamber via a sliding lid. With the lid in the closed position, anesthetic vapor/O2 is introduced into the chamber in the standard fashion. A constant vacuum is applied above the chamber to capture excess gas as it leaves the induction area. When the lid is opened, this vacuum creates negative pressure above the chamber, allowing safe removal of the animal and preventing excess vapor from reaching the investigator. Ideally these units would be connected to in house exhaust with a minimum of 11CFM air movement. In absence of that, you may connect to our Scavenging Cube, Extract-All, or FilterMate Exhaust units.

Dimensions and Specifications:

• Overall: 13.0" x 5.5" x 6.0"


• Induction Chamber Size: 10.0" x 5.5" with a
  ceiling height that slopes from 4.2" to 3.2".


• Lid: Sliding


• Gas Inlet: 15mm ID x 22mm OD


• Exhaust Port: 30mm OD